Snap Ring In Transmission Pan. Last change was 40k ago, so not. I also seem to have a. A few months back replaced filter and fluid and found a large piece of the snap ring in trans pan. 46re wavy snap ring broken. Yesterday i lost reverse, and putting it into 1st it does not brake. Those very rarely break, but it is possible (obviously). If it only needs that one snap ring they could replace it for the cost of the snap ring and get it back to me. Replace it or install a 700r4 or 4l60e forward clutch snap ring. Any transmission parts supplier will carry these snap rings; Last week i was doing fluid/filter change on tranny and found a 2.5 piece of snap ring in the pan. So if you don't have a dummy shaft and a press, take it off and get a trans shop to replace it or let them do the hole job. Fluid was a bit dirty also. At the last tranny service my mechanic found a piece of a broken snap ring sitting in the fluid pan. This one is the od brake wavy snap ring. While performing this service, i found 2 pieces of what appears to be a snap ring as well as metal dust on the pan magnet.
from www.jeepforum.com
While performing this service, i found 2 pieces of what appears to be a snap ring as well as metal dust on the pan magnet. Fluid was a bit dirty also. Yesterday i lost reverse, and putting it into 1st it does not brake. I also seem to have a. If it only needs that one snap ring they could replace it for the cost of the snap ring and get it back to me. A few months back replaced filter and fluid and found a large piece of the snap ring in trans pan. Last week i was doing fluid/filter change on tranny and found a 2.5 piece of snap ring in the pan. This one is the od brake wavy snap ring. Last change was 40k ago, so not. I put in the new sensor,.
42re snap ring repair write up with pics and part numbers
Snap Ring In Transmission Pan I also seem to have a. A few months back replaced filter and fluid and found a large piece of the snap ring in trans pan. At the last tranny service my mechanic found a piece of a broken snap ring sitting in the fluid pan. So if you don't have a dummy shaft and a press, take it off and get a trans shop to replace it or let them do the hole job. If it only needs that one snap ring they could replace it for the cost of the snap ring and get it back to me. Last week i was doing fluid/filter change on tranny and found a 2.5 piece of snap ring in the pan. I put in the new sensor,. Any transmission parts supplier will carry these snap rings; 46re wavy snap ring broken. Those very rarely break, but it is possible (obviously). Replace it or install a 700r4 or 4l60e forward clutch snap ring. This one is the od brake wavy snap ring. Yesterday i lost reverse, and putting it into 1st it does not brake. Last change was 40k ago, so not. While performing this service, i found 2 pieces of what appears to be a snap ring as well as metal dust on the pan magnet. I also seem to have a.
